Adhesive
Products range
anand Group's
  • Anand Paints
  • Anand Organics
  • Anand Industries
  • Anand Coatings
  • Anand Technologies
  • Anand Hi Seas
 
 

Products Discription

Anand Top sealer is a ultimate products to be used an wood surfaces to protects the change from humidity. The products is so finely formulated that it offers an execellent finishing up pores tht uncovered during filling operation. It is esasiar to use and having better binding strength than conventation methode of lakhdana and chapadi.

Technical Data

Area of application

Ancillaries recommenbded

Methode of application

Thinner recommended

Thinner intake

Coverage

Finish

Flash Point

Packes Avilable

:

:

:

:

:

:

:

:

:

Wood

Fillers

by Muslin Cloth Spraying for 20-3- Sec. by ford cup B4 at 30°c

Spraying NCT-24

20 to 25 % by volume

8-10 sq. mtrs /ltr. /coat by spraying a 25 micron thickness at a pressure of 34-40 p.s.i

Smooth

Above 14°c

200 ml, 1/2 ltr, 1 ltr, 4 ltr, 20 ltr.

Direction for uses

  1. Scrub wood throughly and sand with emery paper 220 No.
  2. Wipe off loose dust & clean the surface.
  3. Apply sanding sealer allow it to dry.
  4. Overcoat the surface again.
  5. After drying sand with emery paper 320/400 No. and remove the dust.
  6. Apply top coat.
 
 

Anand Top Wood (P. U. Clear ) gives as ideal finish for different wood surfaces old or new. It is resistant to moisture and highly durable. It offers great resistance to heat, water stains and scratches. It is best suited for interior application

Area of application

Ancillaries recommenbded

 

Methode of application

Thinner recommended

Thinner intake

Coverage

Finish

Flash Point

Packes Avilable

:

:

 

:

:

:

:

:

:

:

Wood

Fillers / Stains

Sealer - Anand's top seal sealer

by Muslin Cloth Spraying for 20-3- Sec. by ford cup B4 at 30°c

Anand reliable (MTO)

20 to 25 % by volume

8-10 sq. mtrs /ltr. /coat by Brushing.

Smooth & Glossy

Above 30 °c

200 ml, 1/2 ltr, 1 ltr, 4 ltr, 20 ltr.

  • For pre polished surfaces :
    1. Send the surface, along the grains.
    2. Clean the surface.
    3. To the surface free of dust and grease, apply a coat of top wood either with brush, muslin cloth or spray gun.
    4. Allow it to dry for 4-6 hrs. and then send with emery paper 320 No.
    5. Apply second coat ot top wood;
  • For new wood surfaces :
    1. Carry out pre-prepration using fillers, if desired stains. Anand's Top Seal Sealer
    2. Then Follow the same procedure as for the pre polished surface.
more..
 
Copyright © Anand Group of Industries 2009-2010 powered by : i-mantra web solution